Lexmark X7500 Setup Guide - Page 19

Power supply (b) Power switch Scanner cable Printer Ethernet cable (e) Network Ethernet cable Telephone fax line cable (d) Power supply line cord (j) Do not plug the power supply line cord into an outlet until later (see "Turning on the control unit and printer" on page 15). 1 Make sure the printer and control unit are turned off and unplugged. 2 Attach the end of the scanner cable with the toroid to the scanner and the other end to the control unit. Tighten the thumbscrews on both ends of the cable. 3 Connect the end of the Ethernet cable (e) with the toroid to the Ethernet port 1 on the control unit and the other end to the printer. 4 Connect the adapter to the telephone fax line cable if necessary. Connect the telephone fax line cable (d) to the control unit and then to a phone jack. 5 Connect standard cabling compatible with your network to the Ethernet port 2 on the control unit, and then to a network connection. This cable is not provided by Lexmark. 6 Connect the power supply (b) to the control unit. Attach cables and cords 11