Maytag MAH5500BWW Service Manual - Page 115

OPTIONS MODE When the extra rinse key is selected, an extra rinse is added for the wash cycles. (Page 1-3 Extra Rinse Table) When max extract speed key is selected, the max extract profile will be used for spin cycle based on the fabric selection. When the stain cycle key is selected, the water input temperature, the wash time, the tumbling pattern, speed, and amount of rinses may be modified. When the presoak key is selected, a presoak is added before the main wash cycle. DISPLAY CHARACTERISTICS Door Locked LED: When the door is finally locked, the door locked LED is lit. When the door is finally unlocked, the door locked LED is not lit. Two Digit Display: The display shows the estimated time remaining in the total cycle in minutes. This time will count down during the total time cycle. If the selected Wash cycle button is pushed, the estimated time remaining in that wash cycle shall be displayed for 5 seconds and the associated Wash level LED will flash. After 5 seconds, the estimated time remaining for the total cycle will be displayed and the wash level LED will return to being on constant. Changing Selections: Fabric, temperature, and options selections may be changed at any time. The current cycle step will be suspended and the appropriate cycle step will be restarted with the new selections. The machine will not stop, but rather the changes will be dynamic. The main Wash Keys may be changed at any time. The cycle time remaining is recalculated and displayed. The remaining time is calculated by applying the actual time in the new cycle. If the user had originally selected Heavy wash and 3 minutes has elapsed and the user then selects Normal wash, the time remaining will be 12 minutes. (e.g. 15 minutes Normal wash minus 3 actual minutes = 12 minutes). If the user had originally selected Quick wash, 1 minute had elapsed, and then the user selects Heavy wash, the new remaining time will be 19 minutes (20 minutes heavy wash minus 1 minute actual time). The main Wash key may not be changed if there is less than 2 minutes time remaining in the wash cycle (Bleach Fill). Although the button can be depressed, the LED status will change but the time remaining or wash cycle will not change. USER INTERFACE SELECTIONS: (LCD Washer) All selections described under the LED washer section are familiar except in the Delay mode. In this mode, time is increased in 15 minute increments up to 12 hours. 16010486 (16008373-05) Revised 02/01 Section 2. Washer Controls Overview ©2001 Maytag Appliances Sales Company 2-3