Netgear FVS336G FVS336G Reference Manual - Page 208

ProSafe Dual WAN Gigabit Firewall with SSL & IPsec VPN FVS336G Reference Manual - For rollover mode, protocol binding does not apply. - For load balancing mode, decide which protocols should be bound to a specific WAN port. - You can also add your own service protocols to the list. 3. Set up your accounts a. Obtain active Internet services such as cable or DSL broadband accounts and locate the Internet Service Provider (ISP) configuration information. • In this document, the WAN side of the network is presumed to be provisioned as shown in Figure C-1, with two ISPs connected to the VPN firewall through separate physical facilities. • Each WAN port must be configured separately whether you are using a separate ISP for each WAN port or are having the traffic of both WAN ports routed through the same ISP. customer premises WAN port 1 FVX538 firewall WAN port 2 route diversity physical facility 1 physical facility 2 ISP 1 ISP 2 Internet Figure C-1 • If your ISP charges by the volume of data traffic each month, consider enabling a traffic meter to monitor or limit your traffic. b. Contact a Dynamic DNS Service and register fully qualified domain names for one or both WAN ports. 3. Plan your network management approach • The VPN firewall is capable of being managed remotely, but this feature must be enabled locally after each factory default reset. You are strongly advised to change the default management password to a strong password before enabling remote management. C-2 Network Planning for Dual WAN Ports v1.0, March 2009