Netgear GS748AT GS724AT/GS748AT Software Administration Manual - Page 105
Switching > STP > Basic > STP Configuration, Global Settings, Spanning Tree State
UPC - 606449059793
View all Netgear GS748AT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 105 highlights
GS700AT Smart Switch Software Administration Manual To configure STP on the device: 1. Click Switching > STP > Basic > STP Configuration. The Basic STP Configuration screen displays: Figure 4-20 The Basic STP Configuration screen contains the following fields: Global Settings • Spanning Tree State - Select the STP state on the device. The possible field values are: - Enable - Enable STP on the device. - Disable - Disable STP on the device. • STP Operation Mode - Select the STP mode on the device. The possible field values are: - STP - Enable classic STP on the device. - RSTP - Enable Rapid Spanning Tree Protocol (RSTP) on the device. • BPDU Handling - Select the method of handling STP BPDUs (Bridge Protocol Data Units) when STP is disabled on the device or interface. The possible field values are: - Filtering - BPDUs are filtered. This the default. - Flooding - BPDUs are flooded to all ports in the system. - Bridging - BPDUs are bridged to all ports in the VLAN. Status • Bridge Identifier - Displays the Bridge priority and MAC address. Configuring Switching Settings v1.0, October 2008 4-28