Netgear HR314 HR314 Reference Manual - Page 92
Power LED Not On, Test LED Never Turns On or Test LED Stays
UPC - 606449024241
View all Netgear HR314 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 92 highlights
Reference Manual for the Model HR314 802.11a Hi-Speed Wireless Router a. The Test LED is not lit. b. The Local port LEDs are lit for any local ports that are connected. c. The Internet port LED is lit. If a port's LED is lit, a link has been established to the connected device. If a Local port is connected to a 100 Mbps device, verify that the port's LED is green. If the port is 10 Mbps, the LED will be amber. If any of these conditions does not occur, refer to the appropriate following section. Power LED Not On If the Power and other LEDs are off when your router is turned on: • Make sure that the power cord is properly connected to your router and that the power supply adapter is properly connected to a functioning power outlet. • Check that you are using the 12VDC power adapter supplied by NETGEAR for this product. If the error persists, you have a hardware problem and should contact technical support. Test LED Never Turns On or Test LED Stays On When the router is turned on, the Test LED turns on for about 10 seconds and then turns off. If the Test LED does not turn on, or if it stays on, there is a fault within the router. If you experience problems with the Test LED: • Cycle the power to see if the router recovers and the LED blinks for the correct amount of time. If all LEDs including the Test LED are still on one minute after power up: • Cycle the power to see if the router recovers. • Clear the router's configuration to factory defaults. This will set the router's IP address to 192.168.0.1. This procedure is explained in "Using the Default Reset Button to Restore the Factory Configuration and Password" on page 9-7. If the error persists, you might have a hardware problem and should contact technical support. 9-2 Troubleshooting