Nikon COOLPIX S1200pj Reference Manual - Page 200

Error Messages The following table lists the error messages and other warnings displayed in the monitor, as well as the solutions for dealing with them. Display O (blinks) N Battery exhausted. Description Clock not set. Battery exhausted. Solution Set date and time. A E 61 Charge or replace the battery. 16, 18 Turn off camera, and allow battery to cool down before resuming use. After five P Battery temperature high Battery temperature is high. seconds, the monitor will turn off and the power-on lamp will blink rapidly. After the 23 lamps blink for three minutes, the camera will turn off automatically. Pressing the power switch also turns off the camera. P The camera turns off The camera will turn The camera has become automatically. Leave the off to prevent hot. camera off until it has cooled 81 overheating. and then turn it on again. N No signal. The camera will turn off. There is no signal from the connected device. Input a signal from the connected device. 81 P Close the projector cover The projector cover is opened. • Close the projector cover • To resume projection, close the projector cover, turn the camera off and back on, 81 and open the projector cover. Q (● blinks red) P Please wait for the camera to finish recording. N Memory card is write protected. Camera cannot focus. • Refocus. • Use focus lock. Camera cannot perform Wait until message clears other operations until from display automatically recording is complete. when recording is complete. Write-protect switch is Slide write-protect switch to in "lock" position. "write" position. 28, 31 68 - - Reference Section E82