Onkyo TX-DS595 Owner Manual - Page 18

Directional linkage - wire diagram

Get Onkyo TX-DS595 PDF manuals and user guides View all Onkyo TX-DS595 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 18 highlights

Connecting antennas Connecting an FM outdoor antenna Please make sure that you follow the considerations: • Keep the antenna away from noise sources (neon signs, busy roads, etc.). • It is dangerous to put the antenna close to power lines. Keep it well away from power lines, transformers, etc. • To avoid the risk of lightning and electrical shock, grounding is necessary. Follow item 14 of the "Important Safeguards" on page 2 when you install the outdoor antenna. Directional linkage Do not use the same antenna for both FM and TV (or VCR) reception since the FM and TV (or VCR) signals can interfere with each other. If you must use a common FM/TV (or VCR) antenna, use a directional linkage type splitter. ANTENNA AM FM 75 To receiver To TV (or VCR) Connecting the antenna cable to the 75/300 Ω antenna adapter (For all models other than USA, Canadian and European models) Connecting the 300 Ω ribbon wire: Loosen the screws and wrap the wire around these screws. Then tighten the screws with a screwdriver. Connecting an AM outdoor antenna An outdoor antenna will be more effective if it is stretched horizontally above a window or outside. • Do not remove the AM loop antenna. • To avoid the risk of lightning and electrical shock, grounding is necessary. Follow item 14 of the "Important Safeguards" on page 2 when you install the outdoor antenna. Outdoor antenna ANTENNA AM (Indoor) AM loop antenna FM 75 Note: If you are using the TX-DS595 worldwide model in a region where AM frequencies are delineated by 10-kHz steps, be sure to set the AM Freq Step Setup setting accordingly (see page 32). Outdoor antenna 300 Ω ribbon wire Connecting the coaxial cable: 1. With your fingernail, or a small screwdriver, press the stoppers of the 75/300 Ω antenna adapter outward and remove the cover. 2. Remove the transformer wire A from slit B and insert it into slit C. 3. Prepare the coaxial cable as shown in the diagram. 4. Connect the 75/300 Ω antenna adapter to the coaxial cable. 1. Insert the end of the cable. 2. Clamp it in place with pliers. 5. Reinstall the cover. 1 2 3, 4 Slit B ✦ ✦ ✦✦ ✦ ✦ 636 mm mm mm 15mm 5/8" Wire A Slit C 18

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
18
Note:
If you are using the TX-DS595 worldwide model in a region where
AM frequencies are delineated by 10-kHz steps, be sure to set the
AM Freq Step Setup setting accordingly (see page 32).
1
2
3, 4
✦
✦
✦
✦
✦
✦
✦
✦
✦
✦
✦
6
mm
3
mm
6
mm
15mm
5/8"
Connecting antennas
Outdoor antenna
(Indoor)
AM loop antenna
To TV (or VCR)
To receiver
Slit B
Wire A
Slit C
Connecting the antenna cable to the 75/300
Ω
antenna adapter (For all models other than USA,
Canadian and European models)
Connecting the 300
Ω
ribbon wire:
Loosen the screws and wrap the wire around these screws. Then
tighten the screws with a screwdriver.
Connecting the coaxial cable:
1.
With your fingernail, or a small screwdriver, press the
stoppers of the 75/300
Ω
antenna adapter outward
and remove the cover.
2.
Remove the transformer wire A from slit B and insert
it into slit C.
3.
Prepare the coaxial cable as shown in the diagram.
4.
Connect the 75/300
Ω
antenna adapter to the coaxial
cable.
1.
Insert the end of the cable.
2.
Clamp it in place with pliers.
5.
Reinstall the cover.
Connecting an AM outdoor antenna
An outdoor antenna will be more effective if it is stretched
horizontally above a window or outside.
•
Do not remove the AM loop antenna.
•
To avoid the risk of lightning and electrical shock, grounding is
necessary. Follow item 14 of the
“
Important Safeguards
”
on
page 2 when you install the outdoor antenna.
Directional linkage
Do not use the same antenna for both FM and TV (or VCR)
reception since the FM and TV (or VCR) signals can interfere with
each other. If you must use a common FM/TV (or VCR) antenna, use
a directional linkage type splitter.
Connecting an FM outdoor antenna
Please make sure that you follow the considerations:
•
Keep the antenna away from noise sources (neon signs, busy
roads, etc.).
•
It is dangerous to put the antenna close to power lines. Keep it
well away from power lines, transformers, etc.
•
To avoid the risk of lightning and electrical shock, grounding is
necessary. Follow item 14 of the
“
Important Safeguards
”
on
page 2 when you install the outdoor antenna.
Outdoor
antenna
300
Ω
ribbon wire
FM
75
AM
ANTENNA
FM
75
AM
ANTENNA