Onkyo TX-DS656 Owner Manual - Page 18

On-screen setting If your TX-DS656 is connected to a TV set, you can perform various settings on the TV screen. This section shows you the basic operation of onscreen setting, as well as the method of changing the screen setup according to your preference. SMART SCAN CONTROLLER jog dial cr 6 -L VIDEO-1 button Selecting the NTSC or PAL system (not available U.S. and. Canadian models) The on-screen display is not output to any of the S-VIDEO connectors. If the picture on the screen scrolls with the TV signal that is being received, change the system setting. Press the VIDEO-1 button to display "OSD". Rotate the SMART SCAN CONTROLLER clockwise or counterclockwise until the desired system appears on the display. If "OSD AUTO" is selected, the unit automatically selects the system used by the connected TV/monitor or projector. 0 0 0. 0 o Cursor buttons/ ENTER button If remote control operation is inoperative... If pressing a remote controller button has no effect on the TX-DS656 even though the remote controller's SENDING/LEARNED indicator lights, verify that the AB-SUBROOM/LEARN switch is set to "A". Note: • On-screen setting is possible only when your TV is connected to the MONITOR OUTPUT V connector. The Menu will not appear if it WIII1Mted tAl the MONITOR OUTPUT ) connector. • The Menu will not be recorded even if it is displayed during recording. • The Menu will not appear if the input selection on the TV is incorrect. Select the correct input channel that is connected to the MONITOR OUTPUT V connector of the TX-DS656. 18