Onkyo TX-DS656 Owner Manual - Page 24
following, procedure, remote, controller, unless otherwise, After, seconds, progress.
View all Onkyo TX-DS656 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Speaker system setup ir POWER button NSIEW 0 EL-,105 OOOO OOc OO O"- O 0 Ebln- O 0 0 00 E.3 000O.-O 0 0 0 CrD a~o LJ ci TEST TONE button LEVEL A/V button Level Calibration using remote controller You can perform level calibration (channel balance setting) independent of the other speaker system settings. In the following procedure, use the remote controller unless otherwise specified. 1. Press the POWER button. 2. Press the TEST TONE button. Press the TEST TONE button again. A test tone is output to each speaker in the following sequence: Left front speaker Center speaker -> Right front speaker -> Right Surround speaker -> Left Surround speaker -> Subwoofer (Returns to Left front speaker) After a few seconds, the test tone automatically travels to the next speaker. 3. While the test tone is output, adjust the output level of the speaker using the LEVEL A or V button. The test signal stays at the same speaker while adjustment is in progress. You can change the channel to which the test tone is output by pressing the CH SEL button. 4. Repeat step 3 to adjust the output level of all speakers. 5. When the adjustment is complete, press the TEST TONE button. The test tone output stops. 24