Onkyo TX-NR5008 Owner Manual - Page 103
Others, Video ATT:OFF
View all Onkyo TX-NR5008 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 103 highlights
Others ■ Stand-by power consumption In the following cases, the power consumption may 65, 76, reach up to a maximum of 30W: 88 1. You are using the Universal Port jack. 2. "Control" is set to "Enable" in the "Network" setting. 3. "HDMI Control(RIHD)" setting is set to "On". (Depending on the TV status, the AV receiver will enter Standby mode as usual.) ■ The sound changes when I connect my headphones When a pair of headphones is connected, the listen- - ing mode is set to Stereo, unless it's already set to Stereo, Mono, Direct, or Pure Audio. ■ The speaker distance cannot be set as required In some cases, corrected values suitable for home - theater use may be set automatically. ■ The display doesn't work The display is turned off when the Pure Audio listen- - ing mode is selected. ■ How do I change the language of a multiplex source Use the "Multiplex" setting on the "Audio Adjust" 54 menu to select "Main" or "Sub". ■ The V functions don't work To use V, you must make an V connection and an 23 analog audio connection (RCA) between the component and AV receiver, even if they are connected digitally. While Zone 2 or Zone 3 is selected, the V func- - tions don't work. ■ The following settings can be made for the S-Video and composite video inputs You must use the buttons on the unit to make these settings. 1. While holding down the input selector button for the input source that you want to set, press SETUP. 2. Use F/S to change the setting. 3. Press the input selector button for the input source that you want to set when you've finished. • Video Attenuation This setting can be made for the BD/DVD, VCR/DVR, CBL/SAT, GAME, or AUX input. If you have a games console connected to the composite video input, and the picture isn't very clear, you can attenuate the gain. Video ATT:OFF: (default). Video ATT:ON: Gain reduced by 2dB. The AV receiver contains a microcomputer for signal processing and control functions. In very rare situations, severe interference, noise from an external source, or static electricity may cause it to lockup. In the unlikely event that this happens, unplug the power cord from the wall outlet, wait at least five seconds, and then plug it back in again. Onkyo is not responsible for damages (such as CD rental fees) due to unsuccessful recordings caused by the unit's malfunction. Before you record important data, make sure that the material will be recorded correctly. Before disconnecting the power cord from the wall outlet, set the AV receiver to Standby. ■ The functions System On/Auto Power On and Direct Change don't work for components connected via V While Zone 2 or Zone 3 is selected, the V func- - tions don't work. ■ When performing "Audyssey MultEQ® XT32 Room Correction and Speaker Setup", the measurement fails showing the message "Ambient noise is too high.". This can be caused by any malfunction in your - speaker unit. Check if the unit produces normal sounds. En 103