Panasonic DC-S1HBODY DC-S1H Basic Operating Manual - Page 195

18. Materials [Failed to connect wireless access point]/[Connection failed]/[No destination found] 0 The wireless access point information set on the camera is wrong. Check the authentication type and encryption key. 0 Radio waves from other devices may block the connection to a wireless access point. Check the status of other devices that are connected to the wireless access point as well as the status of other wireless devices. [Some pictures cannot be deleted]/[This picture cannot be deleted] 0 Images that do not comply with the DCF standard cannot be deleted. Back up any necessary data before formatting the card. (l 39) [Please turn camera off and then on again]/[System Error] 0 Turn off and on the camera. If the message is displayed even when doing this several times, contact the dealer. [The fan is not functioning correctly.] 0 The fan has stopped. Turn off and on the camera. If the fan does not work after turning the camera off and then on again, consult the dealer. 0 The temperature of the camera will rise if you continue to use the camera with the fan stopped. Do not use over long periods of time. Troubleshooting First, try out the following procedures (l 195 to 200). If the problem is not resolved, it may be improved by selecting [Reset] (l 59) on the [Setup] ([Setting]) menu. 0 Please also refer to the "Owner's Manual" (PDF format), which describes more detailed information. The battery becomes flat too quickly. 0 When [6K/4K Pre-Burst] or [Pre-Burst Recording] is set, the battery drains faster. Set these settings only when recording. DVQX1939 (ENG) 195