Panasonic NV-GS500 Operating Instructions - Page 22
Remote control usable range, Selecting the remote control mode, Concerning the button-type battery
View all Panasonic NV-GS500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Before using Caution Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the equipment manufacturer. Discard used batteries according to manufacturer's instructions. Warning Risk of fire, explosion and burns. Do not recharge, disassemble, heat above 100 xC or incinerate. Keep the Button-Type battery out of the reach of children. Never put Button-Type battery in mouth. If swallowed call your doctor. ª Remote control usable range ≥The distance between the remote control and the camera: Within approx. 5 m Angle: Approx. 10o up and 15o down, left, and right ª Selecting the remote control mode If 2 cameras are used simultaneously, set the mode for one pair of movie camera and remote control to [VCR1] and that of the other pair to [VCR2]. This will prevent interference between the 2 pairs. (The default setting is [VCR1]. When the button-type battery is replaced, the setting will revert to the default [VCR1].) 1 Setting on the camera: Set [SETUP] >> [REMOTE] >> [VCR1] or [VCR2]. 2 Setting on the remote control: 2 1 [VCR1]: Press [D] and [∫] simultaneously. 1 [VCR2]: Press [E] and [∫] simultaneously. 2 ª Concerning the button-type battery ≥When the button-type battery runs down, replace it with a new battery (part number: CR2025). The battery is normally expected to last about 1 year, but it depends on operation frequency. ≥Keep the button-type battery out of the reach of children. ≥If the remote control mode of the camera and that of the remote control do not match with each other, "REMOTE" will appear. When the remote control is operated for the first time after the camera is turned on, "CHECK REMOTE MODE" (-57-) will appear and operation is impossible. Set the same remote control mode. ≥The remote control is intended for indoor operation. Outdoors or under strong light, the movie camera may not operate properly even within the usable ranges. 22 VQT0T47