Panasonic PT AX100U Hd Home Cinema Projector - Page 43

Technical Information J Basic format STX Start byte (02h) Command : Parameter 3 bytes 1 byte 1 byte 4 bytes ETX End (03h) The data streaming from the computer will start with STX, and proceed to Command, Parameter and end with ETX. You can add the required parameter. The projector can not receive any command for 10 seconds after the lamp is switched on. Wait 10 seconds before sending the command. If sending multiple commands, check that a response has been received from the projector for one command before sending the next command. When a command which does not require parameters to be sent, the colon (:) is not required. If an incorrect command is sent from the personal computer, the ER401 command will be sent from the projector to the personal computer. J Control commands Command PON POF IIS OMN OEN OBK OCU/OCD/ OCL/OCR OST OFZ OSH OVM VS1 VPM OOT Control contents Power ON Power OFF Input signal selection Menu screen ENTER RETURN Navigation buttons Returning to the default setting Freeze function Shutter function MAIN Aspect ratio selection Picture mode selection SLEEP selection Remarks In standby mode, all commands other than the PON command are ignored. The PON command is ignored during lamp ON control. If a PON command is received while the cooling fan is operating after the lamp has switched off, the lamp is not turned back on again straight away in order to protect the lamp. Parameter: VID = VIDEO IN RG1 = PC IN SVD = S-VIDEO IN YUV = COMPONENT IN HDM = HDMI IN The menu screen will be displayed. Use this command to accept and to activate items selected in the onscreen menus. Use this command to return to a previous menu screen or to clear the menu screen. OCU = F button OCD = G button OCL = I button OCR = H button Use this command to return the setting to the factory default. (page 23) The picture being projected will be paused. Parameter: 0 = OFF 1 = ON Use this command to momentarily turn off the picture. Operation will be switched between ON and OFF each time the command is sent. Do not switch operation ON and OFF after only short periods of time. Use this command to display an item in the PICTURE menu. (page 28) The aspect ratio will be switched each time the command is sent. (page 23) Parameter: NAT=NATURAL DYN=DYNAMIC CN2=CINEMA2 VID=VIDEO (page 28) NOR=NORMAL CN1=CINEMA1 CN3=VIVID CINEMA Setting the duration of time to turn off the power automatically. 0 = OFF 1 = 60 min. 2 = 90 min. 3 = 120 min. 4 = 150 min. 5 = 180 min. 6 = 210 min. 7 = 240 min. (page 23) ENGLISH - 43 Appendix