Panasonic PT-DW100U Dlp Projector - Multi Language - Page 106
Using the Remote 2 terminal
View all Panasonic PT-DW100U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 106 highlights
Using the Remote 2 terminal Using the REMOTE 2 terminal provided on the connection terminals of the main unit, it is possible to operate the projector from a control panel etc. furnished in a distant location where infrared remote control signal cannot be received. Example of a control panel layout Remote terminal External control Remote terminal/External control STANDBY ON LAMP RGB1 VIDEO Projector set up in a meeting room RGB2 S-VIDEO DVI-D Control panel located in a different room Pin assignments and control Be sure to short-circuit Pins # and - when controlling. D-Sub 9-pin (female) external appearance Names of terminals Open (H) Short (L) # GND GND $ POWER OFF ON % RGB1 Other RGB1 & RGB2 Other RGB2 ( VIDEO Other VIDEO ) S-VIDEO Other S-VIDEO * DVI-D Other DVI-D + SHUTTER OFF ON - RST / SET Controlled by Controlled by remote control external contact Note • When pin # and pin - are short-circuited, the following buttons on the projector's control panel and on the remote control cannot be used. POWER button, SHUTTER button In addition, the RS-232C commands and network functions that correspond to these functions cannot be used either. • When pin # and pin - are short-circuited and then any one of pins % to * is short-circuited to pin #, the following buttons on the projector's control panel and on the remote control cannot be used. POWER button, input selection buttons (RGB1, RGB2, DVI-D, AUX, VIDEO, S-VIDEO), SHUTTER button In addition, the RS-232C commands and network functions that correspond to these functions cannot be used either. 106 - ENGLISH