Panasonic VDRD250 VDRD250 User Guide - Page 158

Troubleshooting Problem Cannot register the file with ImageMixer VCD/ DVD2. Cannot select this unit as the write destination drive with ImageMixer VCD/DVD2. The disc for writing is not recognized by ImageMixer VCD/DVD2. The message [There is no work disk space.] is displayed and the data cannot write to disc. The DISC EJECT lever does not work when the unit is connected to the computer. When the USB cable is disconnected, an error message will appear on the computer. Check points ≥ Is there a file with a compatible format in the folder? # Check the help for ImageMixer VCD/DVD2. ≥ In [Options] in the [Select folder], confirm the small box for [Add sub-folder(s)] is checked. ≥ The same folder cannot be selected simultaneously in DVD-Video mode and Video CD mode. In [Selected folder(s)] for the mode not being used, delete the folder. ≥ Cannot write to this unit with ImageMixer VCD/DVD2. # To create a DVD-Video disc, a separate DVD-RW/DVD-R/ +RW/+R drive is required. ≥ If there is a disc in the drive before ImageMixer VCD/DVD2 is started, the drive will not be recognized properly. # 1) Click the upper-right save icon and save the settings. 2) Exit from ImageMixer VCD/DVD2 and remove the disc. 3) Start ImageMixer VCD/DVD2 again, click the [Load Project] button to read the file with the saved settings. 4) Proceed with [Write to Disc] again. ≥ There is not enough work space to write to the disc. # Click the [Preferences] button on the upper-right of ImageMixer VCD/DVD2 and select a work space with a large amount of free space. ≥ The DISC EJECT lever does not work after the unit is connected to the computer. Use the software's eject button to eject the disc. ≥ When the drive icon is displayed on the desktop, drag the icon into the Trash and then disconnect the USB cable. ≥ When the drive icon is not displayed on the desktop, exit the application and then disconnect the USB cable. Others 158 LSQT1011