Pioneer 1140HD Owner's Manual - Page 21

Preparation 05 English 9 mm to 15 mm (3/8 inch to 5/8 inch) 6 mm (1/4 inch) M 8 Preventing the Plasma Display from Falling Over During installation, someone must steady the panel at all times. Stabilizing on a table or floor Stabilize the Plasma Display as shown in the diagram using screws that are 6 mm (1/4 inch) and at least 20 mm (13/16 inch) long (available from your dealer or other hardware sources). 20 mm min. (13/16 inch min.) Using a wall for stabilization 1. Attach fall-prevention bolts (hooks) to the Plasma Display. 2. Use strong cords to firmly attach the panel to a wall, pillar, or other sturdy construction. 3. Repeat attachment for the other side of the panel. NOTE Use hooks, cords, and fittings that are available from your dealer or other hardware sources. Recommended hook: Nominal diameter 8 mm (3/8 inch) Length 12 mm to 15 mm (1/2 inch to 5/8 inch) 12 mm to 15 mm (1/2 inch to 5/8 inch) ➀ Hook ➁ Cord Fitting CAUTION The installation site should have adequate strength to support the Plasma Display. A weak installation site could result in personal injury and property damage. Please take the necessary safety measures to prevent it from falling during emergencies, such as earthquakes or construction accidents. If you do not take these precautions, the Plasma Display could fall, causing injury or property damage. Screws, hooks, chains, and other fittings used to secure the Plasma Display vary according to the composition and thickness of the surface to which the panel is attached. Inspect the mounting surface carefully to determine its thickness and composition; consult a professional installer if necessary. 21 En