Pioneer DVR-550H-S Operating Instructions - Page 54

06 Playback PREV NEXT Press to skip to previous/next chapter/title. (During playback you can also use the front panel CH +/- buttons.) ABC DEF During playback, enter a title GHI JKL MNO number then press ENTER to skip directly to that title. PQRS TUV WXYZ Press CLEAR to clear a number CLEAR CLEAR entry and start again. ENTER BACK CM SKIP (Commercial back/skip) Each press skips backward/forward progressively up to a maximum of two hours in either direction. STEP/SLOW Press to start slow-motion playback. Press repeatedly to change the playback speed. While paused, press to advance a single frame in either direction. Playing CDs and WMA/MP3 discs The table below shows the basic playback controls for audio CDs1, and WMA/MP3 files. PLAY Press to start playback. STOP Press to stop playback. PAUSE Pauses playback, or restarts playback when paused. REV SCAN FWD SCAN Except WMA: Press to start scanning. Press again to increase the scanning speed. (There are two scan speeds; the current scan speed is shown on-screen.) PREV NEXT Press to skip to previous/next track (or folder for WMA/MP3 disc). (During playback you can also use the front panel CH +/- buttons.) ABC DEF During playback, enter a track GHI JKL MNO number then press ENTER to PQRS TUV WXYZ skip directly to that track. Press CLEAR to clear a number CLEAR CLEAR entry and start again. ENTER Playing Video CD/Super VCDs The table below shows the basic playback controls for Video CD/Super VCDs. Some discs feature Playback Control (PBC for short) menus. These discs show PBC in the display when you load them and display a menu on-screen from where you can select what to watch.2 PLAY Press to start playback. Video CD only: If RESUME is displayed on-screen, playback starts from the place last stopped. STOP Press to stop playback. Video CD only: You can resume playback from the same point by pressing PLAY. (Press STOP again to cancel the resume function.) PAUSE Pauses playback, or restarts playback when paused. Note 1 If you want to play a DTS audio CD, make sure the recorder is connected to a DTS-compatible amp/receiver with a digital connection. Noise will be output through the analog outputs. Also make sure that STEREO is selected using the AUDIO button (see Switching audio channels on page 61). 2 When playing in PBC mode, some playback features, such as search, repeat and programme play are not 54 available. You can play a PBC Video CD/Super VCD in non-PBC mode by starting playback using the Disc Navigator (see Using the Disc Navigator with playback-only discs on page 57). En