Poulan PPB4014 Owner Manual - Page 18

Turn the chain tensioner screw with

Get Poulan PPB4014 PDF manuals and user guides View all Poulan PPB4014 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 18 highlights

MAINTENANCE • Lay out the new chain in a loop and straighten any kinks. The cutters should face in the direction of chain rotation. If they face backwards, turn the loop over. • Place the chain drive links into the bar groove. Cutters Chain Rotation Cutters Drive Links NOTE: Make sure the direction of the chain is correct . • Position the chain so there is a loop at the back of the bar. • Hold the chain in position on the bar and place the loop around the sprocket. • Make sure the bar hole fits well with bolt for saw chain tension. • Replace the chain cover. • Turn the chain tensioner screw with the scrench clockwise until the saw chain is properly tensioned. The guide bar must then be pushed upwards, check chain tension again, do not tension the chain too tight. • After the chain is well-tensioned, tighten the bar nuts again. Chain Drive Links Bar Groove 18

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
18
MAINTENANCE
•
Lay out the new chain in a loop and
straighten any kinks. The cutters should
face in the direction of chain rotation. If
they face backwards, turn the loop over.
•
Place the chain drive links into the bar
groove.
NOTE:
Make sure the direction of the chain is
correct .
•
Position the chain so there is a loop at the
back of the bar.
•
Hold the chain in position on the bar and
place the loop around the sprocket.
•
Make sure the bar hole fits well with bolt
for saw chain tension.
•
Replace the chain cover.
•
Turn the chain tensioner screw with the
scrench clockwise until the saw chain is
properly tensioned. The guide bar must
then be pushed upwards, check chain
tension again, do not tension the chain too
tight.
•
After the chain is well-tensioned, tighten
the bar nuts again.
Bar
Groove
Chain Drive Links
Cutters Chain Rotation
Cutters
Drive Links