Poulan PPB4014 Owner Manual - Page 9

ASSEMBLY PACKING LIST • Chainsaw • Scabbard • 2Ah Battery (PPB402AH) • Battery Charger (PPB40CGR) • Owner's Manual If any parts are damaged or missing, please call 1-855-378-6903. WARNING: If any parts are damaged or missing, do not operate this product until the parts are replaced. Failure to heed this warning could result in serious personal injury. Do not attempt to modify this product or create accessories not recommended for use with this product. Any such alteration or modification is misuse and could result in a hazardous condition leading to possible serious personal injury. Do not install the battery until assembly is complete. Failure to comply could result in accidental starting and possible serious personal injury. BATTERY REMOVAL 1. Press the battery release button on the chainsaw. This will cause the battery to raise out of the tool. 2. Grasp the chainsaw firmly and pull the battery out of the handle. BATTERY INSTALLATION 1. Align the battery with the battery opening. 2. Insert the battery into the battery opening until the battery release button locks into place. 3. Push down on the battery until it locks into place. You should hear a "click" once it is installed. • Read, understand, and follow the instructions contained in the charger manual. IMPORTANT: The battery may not be charged when it is purchased. Before using the chainsaw for the first time, place the battery in the battery charger and charge. Make sure to read all safety precautions and follow the instructions in the battery and charger manuals. IMPORTANT:This lithium-ion battery is equipped with an internal circuit breaker which will automatically shut off the power to the tool and then reset itself once cooled. Follow these steps if an overload occurs while under heavy use: • Release the trigger. Restart tool by pressing safety lock-out button and depressing trigger. • Under some conditions, the battery may need to be removed for approximately 1 minute. This allows it to be cooled, reinstall for use. ADDING BAR AND CHAIN LUBRICANT Use a bar and chain lubricant (not included) with this product. It is designed for chains and chain oilers, and is formulated to perform over a wide temperature range with no dilution required. • Remove oil cap. • Carefully pour the bar and chain oil into the tank. • Wipe off excess oil. Replace oil cap. • Check and fill the oil tank when quick view oil indicator is below the second to last indicator line. • Repeat as needed. in orWdeAr toRaNvoIiNd iGnju:rFyoallnodw these instructions to reduce the risk of electric shock or fire: • Replace the battery or the charger immediately if the battery case or charger cord is damaged. • Verify that the switch is in the OFF position before inserting or removing the battery pack. • Verify that the battery is removed and the switch is in the OFF position before inspecting, adjusting, or performing maintenance on any part of the chainsaw. 9