Ridgid MS255SR Operation Manual - Page 31

OPERATION See the following table for correct angle settings and correct positioning of the crown molding on the miter table. 1. Crown molding has a high top rear spring angle (the section that fits flat against the ceiling) of 52° and a bottom rear spring angle (the section that fits flat against the wall) of 38° (for USA). Key Miter Setting Bevel Setting Type of Cut IL 31.6° Right 33.9° Left Inside corner - Left side 1. Position top of molding against fence. 2. LEFT side is finished piece. Inside Corner - Right side IR 31.6° Left 33.9° Right 1. Position top of molding against fence. 2. RIGHT side is finished piece. Outside Corner - Left side OL 31.6° Left 33.9° Right 1. Position top of molding against fence. 2. LEFT side is finished piece. OR 31.6° Right 33.9° Left Outside Corner - Right side 1. Position top of molding against fence. 2. RIGHT side is finished piece. 2. Crown molding with a spring angle of 45° (for Canada). Key Miter Setting Bevel Setting Type of Cut IL 35.3° Right 30.0° Left Inside corner - Left side 1. Position top of molding against fence. 2. LEFT side is finished piece. Inside Corner - Right side IR 35.3° Left 30.0° Right 1. Position top of molding against fence. 2. RIGHT side is finished piece. Outside Corner - Left side OL 35.3° Left 30.0° Right 1. Position top of molding against fence. 2. LEFT side is finished piece. OR 35.3° Right 30.0° Left Outside Corner - Right side 1. Position top of molding against fence. 2. RIGHT side is finished piece. 30