Sharp AR-M237 AR-M237 AR-M277 Operation Manual Suite - Page 130

2 Chapter 2 BASIC OPERATIONS This chapter explains the basic procedures for sending and receiving faxes. SENDING A FAX BASIC PROCEDURE FOR SENDING FAXES The procedure for sending a fax in memory transmission mode (p.14) is explained in the following. 1 Make sure that the machine is in fax mode. SCAN FAX JOB STATUS DATA LINE DATA CUSTOM SE When the [FAX] key light is on, the machine is in fax mode. If the light is not on, press the [FAX] key. 2 Make sure that memory transmission mode is selected. SUB ADDRESS SPECIAL MODES ADDRESS REVIEW DIRECT TX MEMORY TX Memory transmission mode is selected when "MEMORY TX" is highlighted in the [DIRECT TX MEMORY TX] key. If "DIRECT TX " is highlighted, touch the [DIRECT TX MEMORY TX] key. 3 Place the original. 4 Check the original size. EXPOSURE If the address directory STANDARD RESOLUTION screen appears, touch the [CONDITION SETTINGS] key to AUTO 8½x11R ORIGINAL display the condition settings screen (p.7). If you loaded a non-standard size original or the original size was not correctly detected, touch the [ORIGINAL] key and set the original size. ("MANUALLY SETTING THE SCANNING SIZE" (p.20)) 5 If needed, adjust the resolution and exposure settings. AUTO EXPOSURE Resolution: Page 21 Exposure: Page 22 STANDARD RESOLUTION AUTO 8½x11R ORIGINAL If needed, select the sender's name. (p.45) For originals that can be sent, see "ORIGINALS" on page 9. If you are sending multiple pages, scan the pages in order beginning from the first page. Note You cannot place originals in both the RSPF and on the document glass and send them in a single fax transmission. 6 Enter the fax number. The number that you entered appears in the message display ("Condition Setting screen" (p.7 1 )). If it is not correct, press ACC.#-C the [CLEAR] key ( ) and re-enter the number. You can also use the REDIAL key (p.11) or an auto-dial number (p.11). 12