Sharp AR-M355U AR-M355 AR-M455 Operation Manual Suite - Page 370

KEY OPERATOR PROGRAMS ECM (This setting is only effective if the other machine is a G3 machine that supports ECM) Line conditions can sometimes distort a transmitted fax image. When ECM (Error Correction Mode) is turned on, pages that are distorted are automatically re-transmitted. This setting is initially turned on. If turned off, distorted images will be transmitted without being corrected. NOTE If the other machine supports Super G3, ECM will function regardless of the setting. Distinctive ring detection If multiple telephone numbers have been assigned to your telephone line, the number called can be identified by its ringing pattern. By using one number for voice calls and another number for faxes, you can tell which type of call you are receiving by the ringing pattern. You can set your machine to automatically receive faxes when your fax number is called by setting the pattern that corresponds to your fax number. Six selections are available. Normally OFF is selected. Disable of fax number direct entry When the fax function is enabled, this program is used to prohibit dialing of a destination fax number by direct entry with the numeric keys. To prohibit dialing by direct entry with the numeric keys, touch the checkbox to select it. When this is done, faxes can only be sent to destinations that have been stored, and thus this program can be used to restrict fax destinations and prevent accidental transmission to an incorrect number. The following operations are also prohibited: G Storing one-touch dial numbers G Direct entry of fax numbers when storing a group G Direct entry of fax numbers of relay destinations in a relay broadcast memory box I Fax send settings The fax transmission settings allow you to adjust certain parameters for sending faxes to better suit your needs. The fax send settings are as follows: G Auto reduction sending setting G Rotation sending setting G Printing page number at receiver G Call timer at memory sending G Date/own number print position setting G Quick on line sending G Recall in case of line busy G Recall in case of communication error Auto reduction sending setting This setting lets you select whether to have a transmitted document reduced to match the size of the other machine's printing paper. Auto reduction is normally turned on. If the setting is turned off, documents are sent in their original size. Because the size is not adjusted to match the size of the printing paper, part of the received document may be cut off. Rotation sending setting When transmitting a document, this setting allows you to rotate a vertically oriented 8-1/2"x11" (A4) document to a horizontal orientation (8-1/2"x11"R (A4R)), or rotate a 5-1/2"x8-1/2R" (A5R) document to 5-1/2"x8-1/2" (A5). The setting is normally turned on, and documents are rotated counterclockwise. (8-1/2"x11"R (A4R) documents are not rotated.) KEY OPERATOR PROGRAMS ROTATION SENDING SETTING OK ORIGINAL SET SENDING DIRECTION 812 X11 812 X11R 512 X812R 5B152 X812 8 Rotation settings can be separately established for different document sizes. To turn off a rotation setting, touch the checkbox of the appropriate setting to remove the checkmark. Printing page number at receiver This setting lets you select whether page numbers are printed at the top of fax pages by the receiving machine. The normal setting is to have page numbers printed. 8-7