Sharp MX-M363N Installation Manual - Page 7
F. Note for handling PWB and electronic parts, Direct rays of the sun, Gases and chemicals, Vibration
View all Sharp MX-M363N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
(2) Dust If dust enters the machine, it may cause dirty copy and a paper jam, resulting in a shortened lifetime. F. Note for handling PWB and electronic parts When handling the PWB and the electronic parts, be sure to observe the following precautions in order to prevent against damage by static electricity. 1) When in transit or storing, put the parts in an anti-static bag or an anti-static case and do not touch them with bare hands. (3) Direct rays of the sun If the machine is installed under the rays of the sun, the exterior of the machine may be discolored and abnormal copies may be produced. 2) When and after removing the parts from an anti-static bag (case), use an earth band as shown below: • Put an earth band to your arm, and connect it to the machine. (4) Gases and chemicals Do not install the machine at a place where there are gases and chemicals. Especially be careful to avoid installation near a diazotype copier, which produces ammonium gas. Copy quality may be adversely affected and a trouble may be caused. (5) Vibration Avoid installation near a machine which produces vibrations. If vibrations are applied to the copier machine, copy images may be deflected and a trouble may be caused. • When repairing or replacing an electronic part, perform the procedure on an anti-static mat. MX-M503N MX-M283N/M363N/M363U/M453N/M453U/M503N/M503U/M282N/M362N/M452N/M502N 1 - 2