Sony CHC-CL1 Operating Instructions - Page 14

Tuner Presetting radio stations You can preset 20 stations for FM and 10 stations for AM. 1 Press TUNER/BAND repeatedly to select "FM" or "AM". Pressing TUNER/BAND turns on the system. 2 Press and hold m or M until "AUTO" appears. 3 Press m or M. The frequency indication changes and the scanning stops when the system tunes in a station. "TUNED" and "STEREO" (for a stereo program) appear. 4 Press MENU/NO on the remote. 5 Turn ./> (or press . or > on the remote) until "Memory?" appears, then press ENTER/YES on the remote. A preset number appears in the display. The stations are stored from preset number 1. Preset number 6 Press ENTER/YES on the remote. "Complete!" appears, and then the station is stored. 7 Repeat steps 1 to 6 to store other stations. To stop scanning Press m or M. To tune in a station with a weak signal Press m or M in step 2. "MANUAL" appears. Then press m or M repeatedly to tune in the station manually. To set another station to an existing preset number Start over from step 1. After step 5, turn ./ > (or press . or > on the remote) to select the preset number you want to store the other station. To change the AM tuning interval (except for the European model) The AM tuning interval is factory-set to 9 kHz (10 kHz in some areas). To change the AM tuning interval, tune in any AM station first, then turn off the system. While holding STEREO/MONO, turn the system back on. When you change the interval, all the AM preset stations are erased. To reset the interval, repeat the same procedure. Tip The preset stations are retained for about a day even if you disconnect the power cord or if a power failure occurs. 14