Sony DVP-NS900V Operating Instructions - Page 79

Controlling the TV When you set the TV/DVD switch to TV, you can control the following items with the supplied remote. By pressing [/1 VOL +/- WIDE MODE TV/VIDEO CH +/-, number buttons, and ENTER You can Turn the TV on or off Adjust the volume of the TV Switch to or from the wide mode of a Sony wide TV Switch the TV's input source between the TV and other input sources Select the channel of the TV Controlling the volume of your AV amplifier (receiver) with the remote TV/DVD switch [/1 LCD screen Scroll key VOL +/- 1 Slide the TV/DVD switch to DVD. 2 While holding down [/1, press down on the scroll key. "AV P-90" appears in the LCD screen. 3 Release [/1. 4 Toggle the scroll key up or down to select your AV amplifier (receiver's) manufacturer's code (see the table below). 5 Press down on the scroll key. The manufacturer's code flashes and the remote is set. Code numbers of controllable AV amplifiers (receivers) If more than one code number is listed, try entering them one at a time until you find the one that works with your AV amplifier (receiver). If you do not connect an AV amplifier (receiver), you can control your TV's volume by setting the code number to 90 (default). However, you must first set the code number of controllable TVs as explained above. Manufacturer Sony Denon Kenwood Onkyo Pioneer Sansui Technics Yamaha Code number 80, 88, 89, 91 84, 85, 86 92, 93 81, 82, 83 99 87 97, 98 94, 95, 96 Controlling the AV amplifiers (receivers) When you set the TV/DVD switch to DVD, you can control the volume of the AV amplifier (receiver) using VOL +/-. Using Various Additional Functions 79