Sony HVR-Z5E Operation Guide - Page 77
Audio Ch Sel, Dv Audio Mix, Using The Menu, Input1 Trim, Input1 Wind, Input2 Mic Nr, Ch1, Ch2, Ch1+ch2
View all Sony HVR-Z5E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 77 highlights
b Notes • The setting is not effective when you set the INPUT1 switch to LINE. x INPUT1 TRIM You can adjust the input signal level from INPUT1. You can select from [-18dB], [-12dB], [-6dB], [0dB], [+6dB] and [+12dB]. The default setting is [0dB]. b Notes • The setting is not effective when you set the INPUT1 switch to LINE. x INPUT1 WIND B OFF Disables wind noise reduction. ON Enables wind noise reduction. appears on the status check screen. b Notes • The setting is not effective when you set the INPUT1 switch to LINE. x INPUT2 MIC NR x INPUT2 TRIM x INPUT2 WIND You can set INPUT2 in the same way as INPUT1. z Tips • -48dBu is set as 0dB in your camcorder. • Set [INPUT TRIM] to [0dB] for the supplied microphone (ECM-XM1). • Set [INPUT TRIM] to [+12dB] for a microphone with an average sensitivity, including the optional microphone (Sony ECMNV1). • The INPUT TRIM function adjusts the input level from an external microphone. When using a highly sensitive microphone or recording loud sound, set this to the minus side. When using a less sensitive microphone or recording quiet sound, set it to the plus side. • When recording loud sound, the sound may be distorted at either the input point or the recording point. If it is distorted at the input point, adjust the sound using the INPUT TRIM function. If it is distorted at the recording point, lower the total volume level manually. • If you set INPUT TRIM too far to the minus side, the microphone volume becomes too low, resulting in a poor signal to noise ratio. • Test the effect of the INPUT TRIM function according to the microphone used or the sound field of the recording site before actual recording. AUDIO CH SEL B CH1,CH2 Reproduces sound of CH1 and CH2 in respective channels. CH1 Reproduces sound of CH1 in channels 1 and 2. CH2 Reproduces sound of CH2 in channels 1 and 2. CH1+CH2 Reproduces mixed sound of CH1 and CH2 in channels 1 and 2. z Tips • When you select [CH1,CH2] and play back a tape on your camcorder, sound of CH1 + CH2 comes out of the speakers. • When you select [CH1+CH2], the same sound is outputted from right and left speakers of a device to be connected. DV AUDIO MIX You can monitor the sound dubbed from another device or recorded through 4channel microphone during playback. You can set how to output the sound. B CH1,CH2 Outputs only the sound recorded in CH1 and CH2 during recording. MIX Outputs mixed sound of the sound recorded in CH1 and CH2 during Continued , 77 Using the Menu