Sony MZ-NF610 Operating Instructions - Page 78
Messages, Set AVLS to OFF
View all Sony MZ-NF610 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 78 highlights
Messages If the following error messages flash in the display window, check the chart below. Error message Meaning/Remedy AVLS FULL BLANK • AVLS is set to "ON" so that the volume will not increase anymore. , Set AVLS to "OFF" (page 59). • You tried to set the 21st bookmark. , You can set up to 20 bookmarks. Set bookmarks within 20. • An MD with no recording on it is inserted. BUSY • You tried to operate the recorder while it was accessing the recorded data. , Wait until the message goes out (in rare cases, it may take a few minutes). CannotCHG • You tried to charge at a place where the temperature is too high. , Charge the battery at a temperature of 5°C (+41°F) to +40°C (+104°F). Edit • The MD player is recording information (track start and end position) from the memory to the disk. , Wait until this process is completed. Do not expose the player to physical shock, nor disrupt power supply. ERROR • There is an internal malfunction in the system. , Restart the operation by doing steps 1 to 3 on page 77. If the message appears again, please consult your nearest Sony dealer. FULL • The remaining recording time on the disc is 12 seconds (stereo), 24 seconds (LP2 stereo or monaural), 36 seconds (LP4 stereo), or less. , Replace the disc. • You tried to enter more than 200 letters to label a single track or disc. • You tried to enter a total of more than 1,700 letters for track or disc names. • You tried to create a 100th group. , You can create only up to 99 groups on a disc. Keep the group number within 99. HiDCin • Voltage of the power supply is too high (The supplied AC power adaptor or the recommended car battery cord is not used). , Use the supplied AC power adaptor or the recommended car battery cord. HOLD • The recorder is locked. , Slide HOLD against the arrow to unlock the recorder (page 20). 78