Sony RM-AV2500 Operating Instructions (primary manual) - Page 17
When you teach signals to the, VOLUME or MUTING buttons, air-conditioner, Continued - program code
View all Sony RM-AV2500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Notes • If you do not perform learning steps within two minutes, learning mode ends. • If you do not perform Step 4 within 10 seconds after Step 3, the display turns back to the display in Step 2. (All the learnable keys flash.) In this case, perform Step 3 again while the display is flashing. • If "NG" appears while learning, the memory is full. To free memory, clear learned functions from keys that you do not use often (page 19). Then continue the learning steps. • If you touch a key by mistake in step 4, while pressing the LIGHT button, press the mistaken key. Then repeat from Step 3 to continue learning. If the Commander does not seem to be working If the learned key or button does not operate properly, teach once again. (For example, if the volume becomes very loud after pressing the VOLUME + button only once, noise may have interfered during the learning procedure.) If you set a component code after learning a signal If you have programmed any signal for a key or button using the learning function, that signal will remain assigned to that key or button even after you set a component code. When you teach signals to the VOLUME or MUTING buttons •If you have programmed any signal on the VOLUME or MUTING button for components other than TV and AMP using the learning function, that signal will be transmitted only when you select that component. •If you have programmed any signal on the VOLUME or MUTING button for TV or AMP using the learning function, that signal will be transmitted only when you select TV or AMP. When you select other components, the preset volume control signals for TV or AMP will be transmitted (for the difference between visual components and audio components, see page 21). To use the learned signal, you need to program the VOLUME or MUTING button for each component using the learning function. When you teach the signals of an air-conditioner See the notes on page 37. Continued 17