Sony RM-AV2500 Operating Instructions (primary manual) - Page 41

To receive the data of a Component Select button from another remote commander 1~2 Perform Steps 1 and 2 on page 40. 3 Press the 2 key. 4 Press the Component Select button to which want to assign the data. 5 Press the ENTER key. Selecting a Channel with a Single Key Press - Channel Macro Function You can program the Channel Macro function for the keys listed below (macro keys). If you program the operation of entering the 1, 2, 3 and ENTER keys for a macro key, you can select the channel 123 by pressing that single key. Component Macro key TV: PIP INPUT, PIP MOVE, PIP CH+, PIP STILL, PIP SWAP, PIP CH- CBL: m, N, M, REC*, x, X SAT: m, N, M, x, X * You can program this function for REC key alone (not on the REC + B key for a doublekey operation). When the data have been received, "TV" and "r" go off. If the data have been successfully received, the 2 VOLUME CHANNEL backlight of the display turns off. Notes • If the Commander is not ready for receiving the data, press CLEAR key, then OK key to clear the learned signal on all or one of the Component Select buttons. • If "NG" appears during data transfer, go back to Step 3 and continue the operation OK MENU EXIT SYSTEM CONTROL A B C MORE MUTING RECALL LIGHT COMMANDER OFF TV CBL SAT DVR VCR M1 AMP CD MD TAPE DVD M2 1 5 or press COMMANDER OFF to stop the operation. If you continue the operation, you have to set the sending remote commander again to send data. Continued 41