Sony STR DA5500ES Operating Instructions - Page 190
Remote commander, Network, Preparing for the BRAVIA Sync
UPC - 027242754324
View all Sony STR DA5500ES manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 190 highlights
HDMI function does not work properly for a long time, perform the steps given in "Preparing for the "BRAVIA" Sync" (page 112). • When you select "HDMI B" or "OFF," the Control for HDMI function does not work properly. No sound is output from the receiver and TV speaker while using the System Audio Control function. • Make sure the TV is compatible with the System Audio Control function. • If the TV does not have System Audio Control function, set the "Audio Out" settings in HDMI settings menu to - "TV+AMP" if you want to listen to the sound from the TV speaker and receiver. - "AMP" if you want to listen to the sound from the receiver. • When you connect the receiver to a video component (projector, etc.), sound may not be output from the receiver. In this case, select "AMP." • You cannot listen to the sound of a component connected to the receiver while a TV is selected as the input on the receiver. - Change the input of the receiver to HDMI when you want to watch a program on a component connected to the receiver. - Change the TV channel when you want to watch a TV broadcast. - Select the component or input you want to watch when you watch a program on the component connected to the TV. Refer to the operating instructions of the TV on this operation. • When using the Control for HDMI function, you cannot control the connected component using TV's remote. - Depending on the connected component and TV, you may need to set up the component and TV. Refer to the operation instructions supplied with each component and TV. - Change the input of the receiver to the HDMI input connected to the component. Remote commander The remote does not function. • Point the remote at the remote sensor on the receiver. • Remove any obstacles in the path between the remote and the receiver. • Replace all the batteries in the remote with new ones, if they are weak. • Make sure that the command modes of the receiver and the remote are the same. If the command mode of the receiver and the remote are different, you cannot operate the receiver with the remote (page 124). • Make sure you select the correct input on the remote. • When you operate a programmed nonSony component, the remote may not function properly depending on the model and the maker of the component. Network Cannot find the server. • Check the following: - Is the router is turned on? - If there is another device between this device and the router, check that device is turned on. - Are all of the cables are connected correctly and securely? - Is the settings to make sure that they match the router's settings (DHCP or fixed IP address)? • When using a computer, check the following: - the built-in firewall settings for the computer's operating system. - the firewall settings of your security software. To check the firewall settings of your security software, refer to your security software's Help section. 190GB