Sony STR DA5500ES Operating Instructions - Page 47
: Preparing the receiver and the remote, Release the TONE MODE - reset
UPC - 027242754324
View all Sony STR DA5500ES manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 47 highlights
Getting Started 6: Preparing the receiver and the remote Connecting the AC power cord (mains lead) Connect the supplied AC power cord (mains lead) to the AC IN terminal on the receiver, then connect the AC power cord (mains lead) to a wall outlet. Notes • Before connecting the AC power cord (mains lead), make sure that metallic wires of the speaker cords are not touching each other between the SPEAKERS terminals. • Connect the AC power cord (mains lead) firmly. AC IN terminal To the wall outlet AC OUTLET (USA/Canadian model only) AC power cord (mains lead) (supplied) Performing initial setup operations Before using the receiver for the first time, initialize the receiver by performing the following procedure. This procedure can also be used to return settings you have made to their factory defaults. POWER TONE MODE HDMI IN 1 Press POWER to turn off the receiver. 2 Hold down POWER while pressing TONE MODE and HDMI IN to turn on the receiver. 3 Release the TONE MODE and HDMI IN after a few seconds. After "MEMORY CLEARING..." appears on the display for a while, "MEMORY CLEARED." appears. All the settings you have changed or adjusted are reset to the initial settings. Note It takes about 30 seconds for the memory to be cleared completely. Do not turn the receiver off until "MEMORY CLEARED." appears on the display. A several space is left between the plug and the rear panel even when the power cord (mains lead) is inserted firmly. The cord is supposed be connected this way. This is not malfunction. 47GB