Sony STR DA5500ES Operating Instructions - Page 54
Saving the measurement results, Press, to select Yes in, step 7 in Performing auto
UPC - 027242754324
View all Sony STR DA5500ES manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 54 highlights
Saving the measurement results To save the measurement results obtained in "Performing auto calibration" (page 51), proceed with the following steps. 1 Press B/b to select "Yes" in step 7 in "Performing auto calibration" (page 51), then press . The selecting screen of the calibration type appears. 2 Press V/v repeatedly to select the auto calibration type, then press . Parameter Explanation Full Flat Makes the measurement of frequency from each speaker flat. Engineer Sets the frequency to one that matches that of the Sony listening room standard. Front Reference Adjusts the characteristics of all the speakers to match the characteristics of the front speaker. OFF Sets the auto calibration EQ to off. The measurement results are saved. 3 Press b. The exit screen appears. 4 Press . Notes • After reflecting the results of a compensation for a frequency characteristic, signals with a sampling frequency of 88.2 kHz and higher are always played back at either 44.1 kHz or 48 kHz. • The frequency response measurement result is not utilized in the following cases. - The multi-channel input is selected. - "2ch Analog Direct" is being used. - Dolby TrueHD signals with a sampling frequency of 176.4 kHz and higher are being received. Tip The size of a speaker (LARGE/SMALL) is determined by the low characteristics. The measurement results may vary, depending on the position of the optimizer microphone and speakers, and the shape of the room. It is recommended that you follow the measurement results. However, you can change those settings in the Speaker settings menu. Save the measurement results first, then try to change the settings if you want. 54GB