Sony VPL-CX76 Operating Instructions - Page 15

To connect to a video GBR/ Component output connector Left side Projecting ON/STANDBY indicator Projecting the Picture Rear remote control detector to audio output (L) to audio output (R) to video GBR/ component output VCR A SMF-402 Signal Cable (not supplied) HD D-sub 15-pin (male) ↔ 3 × phono jack B Stereo audio connecting cable (not supplied) (Use a no-resistance cable.) Notes • Set the aspect ratio using "Wide Mode" on the INPUT SETTING menu according to the input signal. • When you connect the projector to a video GBR output connector, select "Video GBR" or when you connect the projector to a component output connector, select "Component" with the "Input-A Signal Sel." setting on the SET SETTING menu. • Use the composite sync signal when you input the external sync signal from video GBR/component equipment. 1 Plug the AC power cord into a wall outlet, then connect all equipment. The ON/STANDBY indicator lights in red and the projector goes into standby mode. 2 Press the ?/1 key. The ON/STANDBY indicator flashes in green and the Advanced Intelligent Auto-setup starts. The lens protector opens, the powered tilt adjuster rises and stops at the previously adjusted position and adjusts the focus. Projecting 15