Sony VPL-CX76 Operating Instructions - Page 30

Setting items Power Saving IR Receiver Illumination Panel Key Lock Functions Initial setting When set to "On," the projector goes into power saving Off mode if no signal is input for 10 minutes. Although the lamp goes out, the cooling fan keeps running. The power saving mode is canceled when a signal is input or any key is pressed. In power saving mode, no keys function for the first 45 seconds after the lamp goes out. Selects the remote control detectors (IR Receiver) on the front and rear of the projector. • Front & Rear: Activates both the front and rear detectors. • Front: Activates the front detector only. • Rear: Activates the rear detector only. Front & Rear Selects whether the SONY logo on the top panel of the On projector lights when the projector is on. Normally, this setting is "On." Locks all the control panel keys on the rear and side Off panels of the projector so that the projector can be operated only with the Remote Commander. To lock the control panel keys, set to "On." When it is set to "On," keeping the ?/1 key on the control panel pressed for 10 seconds turns the projector on when it is in standby mode, and turns the projector to standby mode when the power is on. If you press and hold the MENU key for about 10 seconds when the power is on, the lock will be released and "Panel Key Lock" is automatically set to "Off." Notes • Press the APA key when the full image is displayed on the screen. If the projected image includes a black portion around it, the APA function will not work properly and some parts of the image may not be displayed on the screen. • You can cancel the adjustment by pressing the APA key again while "Adjusting" appears on the screen. • The picture may not be adjusted properly depending on the type of input signal. • Adjust the "Dot Phase," "H Size," and "Shift" items on the INPUT SETTING menu when you adjust the picture manually. 30 The SET SETTING Menu