TP-Link 16dBi PharOSUN V1 User Guide - Page 40
WAN, Network Tab
View all TP-Link 16dBi manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
Chapter 5 Network Tab you finish all settings, otherwise all the settings will be recovered to last saved settings at reboot or power off. WAN NOTE: WAN submenu is only available on AP router mode and AP client router (WISP Client) mode. There are five WAN connection types: Static, Dynamic, PPPoE, L2TP, and PPTP. Select the suitable one to configure the IP parameters of the WAN on the screen below. If you are not sure of the connection type, please consult your ISP. Static This connection type uses a permanent, fixed (static) IP address that your ISP assigned. In this type, you should fill in the IP address, Netmask, Gateway IP, and DNS IP address manually, which are specified by your ISP. IP Address Netmask Enter the IP address provided by your ISP. Enter the Netmask provided by your ISP. Normally use 255.255.255.0 as the netmask. - 37 -