TP-Link T2600G-28SQ T2600G Series Switches CLI Reference Guide Guide - Page 135

Command Mode Interface Configuration Mode (interface gigabitEthernet / interface range gigabitEthernet) Privilege Requirement Only Admin, Operator and Power User level users have access to these commands. Example Enable Port Security function for port 1/0/1, select Static mode as the learn mode, and specify the maximum number of MAC addresses that can be learned on this port as 30. When the number of MAC address entries reaches 30 on this port, new entry will be dropped: T2600G-28TS(config)# interface gigabitEthernet 1/0/1 T2600G-28TS(config-if)# mac address-table max-mac-count max-number 30 mode static status drop 14.7 mac address-table notification (interface) Description The mac address-table notification command is used to configure the MAC change notification on port. Syntax mac address-table notification { [ learn-mode-change enable | disable ] [ new-mac-learned enable | disable ] } Parameter learn-mode-change enable | disable -- Enable/Disable the learn-mode-change notification. With this feature enabled, a SNMP notification is generated and sent to the network management system (NMS) when the learning mode of this port changes. To configure the learning mode configuration, please refer to mac address-table max-mac-count. new-mac-learned enable | disable -- Enable/Disable the new-mac-learned notification on this port. With this feature enabled, a SNMP notification is generated and sent to the network management system (NMS) when the port learns a new MAC address. 112