TP-Link T2600G-28SQ T2600G Series Switches CLI Reference Guide Guide - Page 520

port-pwr-change --Triggered when the total power required by the connected PDs exceeds the maximum power the PoE switch can supply. port-pwr-deny --Triggered when the switch powers off PDs on low-priority PoE ports. When the total power required by the connected PDs exceeds the system power limit, the switch will power off PDs on low-priority PoE ports to ensure stable running of the other PDs. port-pwr-over-30w --Triggered when the power required by the connected PD exceeds 30 watts. port-pwr-overload --Triggered when the power required by the connected PD exceeds the maximum power the port can supply. port-short-circuit --Triggered when a short circuit is detected on a port. thermal-shutdown --Triggered when the PSE chip overheats. The switch will stop supplying power in this case. Command Mode Global Configuration Mode Privilege Requirement Only Admin level users have access to these commands. Example Enable all PoE traps for the switch: T2600G-28MPS(config)# snmp-server traps power 58.16 snmp-server traps link-status Description The snmp-server traps link-status command is used to enable SNMP link status trap for the specified port. To disable the sending of SNMP link status trap, please use no snmp-server traps link-status command. By default, it is disabled. Syntax snmp-server traps link-status no snmp-server traps link-status Command Mode Interface Configuration Mode (interface gigabitEthernet / interface range gigabitEthernet) 497