TP-Link T2600G-28SQ T2600G Series Switches CLI Reference Guide Guide - Page 436

Command Mode Global Configuration Mode Privilege Requirement Only Admin, Operator and Power User level users have access to these commands. User Guidelines Before binding an IPv6 ACL to a VLAN or interface, you should configure the SDM template as "enterpriseV6" and save your configurations. Example Create IPv6 ACL 1600 and configure Rule 1 to deny packets with source IPv6 address CDCD:910A:2222:5498:8475:1111:3900:2020: T2600G-28TS(config)# access-list create 1600 T2600G-28TS(config)# access-list ipv6 1600 rule 1 deny logging disable sip CDCD:910A:2222:5498:8475:1111:3900:2020 sip-mask ffff:ffff:ffff:ffff 47.8 access-list packet-content config Note: T2600G-18TS does not support Packet Content ACL. Description The access-list packet-content config command is used to add Packet Content ACL rule. To delete the corresponding rule, please use no access-list packet-content config command. Packet content ACLs analyze and process data packets based on 4 chunk match conditions, each chunk can specify a user-defined 4-byte segment carried in the packet's first 128 bytes. Syntax access-list packet-content config acl-id-or-name rule {auto | rule-id } {deny | permit} logging {enable | disable} [chunk0 value mask0 mask] [chunk1 value mask1 mask] [chunk2 value mask2 mask] [chunk3 value mask3 mask] [tseg time-segment] no access-list packet-content config acl-id-or-name rule rule-id Parameter acl-id-or-name -- Enter the ID or name of the ACL that you want to add a rule for. 413