TP-Link T2600G-28SQ T2600G Series Switches CLI Reference Guide Guide - Page 519

Syntax snmp-server traps ip { change | duplicate } no snmp-server traps ip { change | duplicate } Parameter change --Enable SNMP IP change traps. The trap monitors the IP changed of each interface. The trap can be triggered when the IP address of any interface is changed. duplicate --Enable SNMP IP duplicate traps. The trap can be triggered when the switch detects an IP conflict event. Command Mode Global Configuration Mode Privilege Requirement Only Admin level users have access to these commands. Example Enable the IP-Change trap for the switch: T2600G-28TS(config)# snmp-server traps ip change 58.15 snmp-server traps power Note: Only T2600G-28MPS supports this command. Description The snmp-server traps power command is used to enable PoE traps. The command without parameter enables all PoE traps. To disable this feature, please use no snmp-server traps power command. All PoE traps are disabled by default. Syntax snmp-server traps power [over-max-pwr-budget | port-pwr-change | port-pwr-deny | port-pwr-over-30w | port-pwr-overload | port-short-circuit | thermal-shutdown ] no snmp-server traps power [over-max-pwr-budget | port-pwr-change | port-pwr-deny | port-pwr-over-30w | port-pwr-overload | port-short-circuit | thermal-shutdown ] Parameter over-max-pwr-budget --Triggered when the total power required by the connected PDs exceeds the maximum power the PoE switch can supply. 496