TP-Link T2600G-28SQ T2600G Series Switches CLI Reference Guide Guide - Page 343

User Guidelines This command should be used along with the storm-control command to enable the storm control function and specify the detailed parameters. Example Set the storm control mode as pps on port 1/0/5: T2600G-28TS(config)# interface gigabitEthernet 1/0/5 T2600G-28TS(config-if)# storm-control rate-mode pps 35.2 storm-control Description The storm-control command is used to enable the broadcast, multicast, or unknown unicast strom control function and to set threshold levels on an interface. To return to the default configuration, please use no storm-control command. Syntax storm-control { broadcast | multicast | unicast } { rate } no storm-control { broadcast | multicast | unicast } Parameter broadcast | multicast | unicast -- Select the mode of the storm control on the interface. rate -- Specify the bandwidth for receiving packets on the port. The specified type of packet traffic exceeding the bandwidth will be processed according to the configuration of storm-control exceed command. For kbps, the rate ranges from 1 to 1000000 kbps. For ratio, the rate ranges from 1 to 100 percent. For pps, the rate ranges from 1 to 1488000 packets per second. Command Mode Interface Configuration Mode (interface gigabitEthernet / interface range gigabitEthernet / interface port-channel / interface range port-channel) Privilege Requirement Only Admin, Operator and Power User level users have access to these commands. User Guidelines Before you configure the storm-control type as kbps or ratio, pelease ensure that the port is not in pps mode. 320