TP-Link T2600G-28SQ T2600G Series Switches CLI Reference Guide Guide - Page 439

T2600G-28TS(config)# access-list action 6 rule 1 T2600G-28TS(config-action)# redirect interface gigabitEthernet 1/0/1 47.11 s-condition Description The s-condition command is used to limit the rate of the matched packets. To restore the settings to the defaults, please use no s-condition. Syntax s-condition rate rate burst burst-size osd { none | discard | remark dscp dscp } no s-condition Parameter rate -- Specify a rate, ranging from 0 to 1000000kbps. burst-size -- Specify the number of bytes allowed in one second ranging from 1 to 128. osd --Select either "none", "discard" or "remark dscp" as the action to be taken for the packets whose rate is beyond the specified rate. The default is None. When "remark dscp" is selected, you also need to specify the DSCP value for the matched packets. The DSCP value ranges from 0 to 63. Note: Remark DSCP is not available for T2600G-18TS. Command Mode Action Configuration Mode Privilege Requirement Only Admin, Operator and Power User level users have access to these commands. Example Configure a policy for rule 1 of ACL 6: limit the transmission rate of the matched packets as 1000 Kbps and if the number of bytes per second is beyond 100, the packets will be discarded by the switch: T2600G-28TS(config)#access-list action 6 rule 1 T2600G-28TS(config-action)# s-condition rate 1000 burst 100 osd discard 416