Toshiba Tecra M2-S519 Maintenance Manual - Page 205

3.29 SETUP 3 Tests and Diagnostics (c) Parallel Port Mode The options in this tab are ECP and Standard Bi-directional. ECP Sets the port mode to Extended Capabilities Port (ECP). For most printers, the port should be set to ECP. (Default) Std. Bi-Direct. This setting should be used with some other parallel devices. (d) Hard Disk Mode Use this item to select the hard disk mode. Enhanced IDE (Normal) Select this mode when using an operating system that supports Enhanced IDE. (Default) Standard IDE Select this mode when using an operating system that does not support Enhanced IDE. NOTE: Formats for Enhanced IDE and Standard IDE are different, so if you change the setting, you will have to reformat the hard disk for the appropriate setting. 15. Legacy Emulation. (a) USB KB/Mouse Legacy Emulation. Use this option to enable or disable USB KB/Mouse Legacy Emulation. If your operating system does not support USB, you can still use a USB mouse and keyboard by setting the USB KB/Mouse Legacy Emulation item to Enabled. Enabled USB Legacy Support can be used. (Default) Disabled USB Legacy Support cannot be used. (b) USB-FDD Legacy Emulation. Use this option to enable or disable USB-FDD Legacy Emulation. Enabled USB Legacy Support can be used. (Default) Disabled USB Legacy Support cannot be used. 16. PCI LAN This option enables/disables the Built-in LAN functions. (a) Built-in LAN Enabled Disabled Enables Built-in LAN functions. (Default) Disables Built-in LAN functions. TECRA M2 Maintenance Manual (960-468) 3-91