Toshiba Tecra M2-S519 Maintenance Manual - Page 255
Installing the Wireless LAN board, Wireless LAN board
View all Toshiba Tecra M2-S519 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 255 highlights
4.13 Wireless LAN board 4 Replacement Procedures 2. Press the latches outward to release the wireless LAN board. 3. Disconnect the wireless LAN board from the connector on the system board. Be careful not to damage the connector. Installing the Wireless LAN board To install the wireless LAN board, make sure that the computer is in boot mode and powered off, follow the steps below and refer to figures 4-25. CAUTION: Be sure to switch the computer off before installing the wireless LAN board. Otherwise, the computer or the wireless LAN board may be damaged. 1. Insert the wireless LAN board into the connector on the system board. 2. Gently push the wireless LAN board down until the latches on both sides are engaged. 3. Connect the wireless LAN antenna cables (black and white) to the connectors on the wireless LAN board. CAUTION: There are two MAC address barcode labels in the package containing the new wireless LAN board. Apply one label on the wireless LAN board and one on the box the computer was in. Before you apply the new labels, remove the old ones from the wireless LAN board and the box. The computer may have MAC address barcode labels for both wired and wireless LANs. Be sure to replace the correct label. TECRA M2 Maintenance Manual (960-468) 4-41