Xerox 750DX 5750 Error Codes List - Page 21

Status Code Tray Paper Size Sensing for Tray 1, Tray 2, Tray 3, Tray 4, or the Bypass Tray Description/Direction The control logic has sensed that the the paper size is not being detected correctly. Initial action: Go to the Paper Tray which was selected on the Control Panel and verify that the Paper Size Indicator is set to the correct paper size that is loaded in the Paper Tray. Go to the Paper Tray which was selected on the Control Panel and verify that the paper is loaded correctly. NOTE : Check for obvious damage, missing or broken Drive Motor gear assemblies and drive belts. These items may cause a sensor failure to be displayed as an operator error message. If the problem still exists: Place a service call. 08-105, 110, 115, 120 The control logic sensed a timing problem from the Feed Out sensor for Tray 1 (08-105), Tray 2 (08-110), Tray 3 (08115) or Tray 4 (08-120). Initial action: For the appropriate tray, check the Tray Feed Out Sensor actuator for freedom of movement and proper installation. Check for proper installation of the appropriate Paper Guide. For the appropriate tray, check the Feed Sensor, Nudger, Retard and Feed Rolls shaft, for cleanliness, damage and excessive wear. Clean the Feed, Retard and Nudger Rolls with a damp cloth (water) (REP 5.22) (REP 5.24). Fan the paper or replace the paper with a new ream of paper. If the problem still exists: Place a service call. 5750 DocuCare Service Manual 5/98 2-21 Fault Code Procedures