Xerox 750DX 5750 Error Codes List - Page 34
Saver mode was exited.
UPC - 042215455060
View all Xerox 750DX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
Status Code 10-373 Description/Direction The control logic sensed that the Pressure Roll could not maintain temperature during a copy run. Initial action: Ensure that the Pressure Roll surface is clean (no debris, paper, etc.) (REP 5.35) Check the Pressure Roll Control Thermistor for cleanliness, damage and excessive wear at the point where the Thermistor contacts the Pressure Roll (REP 5.37). If the problem still exists: Place a service call. 10-374 The control logic sensed that the Pressure Roll did not reach operating temperature within 150 seconds after Power Saver mode was exited. Initial action: Ensure that the Pressure Roll surface is clean (no debris, paper, etc.) (REP 5.35) Check the Pressure Roll Control Thermistor for cleanliness, damage and excessive wear at the point where the Thermistor contacts the Pressure Roll (REP 5.37). If the problem still exists: Place a service call. 10-375, 376 The control logic sensed that the Pressure Roll temperature exceeded 180˚. Initial action: Check the Pressure Roll Control Thermistor for cleanliness, damage and excessive wear at the point where the Thermistor contacts the Pressure Roll (REP 5.37). If the problem still exists: Place a service call. Fault Code Procedures 5/98 2-34 5750 DocuCare Service Manual