Xerox 750DX 5750 Error Codes List - Page 28

Reset NVM6060 to 0.

Page 28 highlights

Status Code 09-365, 366, 367, 368 Description/Direction The control logic sensed a failure of one of the toner dispensing systems. Yellow (09-365), Magenta (09-366), Cyan (09-367), or Black (09-368). Initial action: Remove the corresponding toner cartridge and check for caking of the toner or blockage of the opening. Verify that there is adequate toner in the cartridge. If the problem still exists: Place a service call. 09-376 The control logic sensed that the Waste Toner Sump is full. Initial action: Refer to proceedure (REP 5.5) to clean the waste toner sump. Reset NVM6060 to 0. If the problem still exists: Place a service call. 09-620 The control logic sensed a failure of the ADC sensor setup. Initial action: Check the drum surface for damage or deformities (REP 5.4). If the problem still exists: Place a service call. Fault Code Procedures 5/98 2-28 5750 DocuCare Service Manual

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40

5/98
Fault Code Procedures
2-28
5750 DocuCare Service Manual
09-365,
366, 367,
368
The control logic sensed a failure of one of the toner dispensing systems. Yellow (09-365), Magenta (09-366), Cyan
(09-367), or Black (09-368).
Initial action:
Remove the corresponding toner cartridge and check for caking of the toner or blockage of the opening.
Verify that there is adequate toner in the cartridge.
If the problem still exists:
Place a service call.
09-376
The control logic sensed that the Waste Toner Sump is full.
Initial action:
Refer to proceedure
(REP 5.5) to clean the waste toner sump.
Reset NVM6060 to 0.
If the problem still exists:
Place a service call.
09-620
The control logic sensed a failure of the ADC sensor setup.
Initial action:
Check the drum surface for damage or deformities (REP 5.4).
If the problem still exists:
Place a service call.
Status
Code
Description/Direction