Xerox 8200B Network Users Guide - Page 32
Macintosh EtherTalk Network (MacOS 8.x/9.x/X, version 10.1), Requirements, Enabling EtherTalk
UPC - 095205082128
View all Xerox 8200B manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
Phaser® 8200 Color Printer Macintosh EtherTalk Network (MacOS 8.x/9.x/X, version 10.1) This section provides installation and troubleshooting steps for Macintosh (MacOS 8 through X, version 10.1): I Quick install steps for MacOS 8.x and 9.x - see page 28. I Quick install steps for MacOS X, version 10.1 - see page 30. I Setting up the Macintosh Ethernet port for TCP/IP or AppleTalk - see page 30. I Macintosh troubleshooting step-by-step - see page 31. Requirements I A workstation with the appropriate driver installed. I A working knowledge of the operating system (System 8.0+ or higher) being used on your workstation. I Proper cabling in use to connect your printer to the network. Enabling EtherTalk If you use EtherTalk, Macintosh computers do not require IP addresses. 1. Open the AppleTalk Control Panel. 2. Verify that the Ethernet port is the selected network port. 3. To install the printer driver, double-click the installer on the Software and Documentation CD-ROM. Perform the next two steps for MacOS 8.x and 9.x. 1. Open the Chooser, select the LaserWriter driver. 2. From the right column of the Chooser, select the printer. Click Create to create the desktop printer. Perform the next two steps for MacOS X, version 10.1 only. 1. Open Print Center. 2. Click Add Printer, select the printer, then click Add. For more details, refer to the infoSMART Knowledge Base at www.xerox.com/officeprinting/ infoSMART, Document #2562. Copyright © 2002 Xerox Corporation. All Rights Reserved. 27