Xerox M20I System Administration Guide - Page 36
Manually setting TCP/IP Addresses, System Admin Tools, Passcode Protect], Network Setup] - service manual
UPC - 095205244205
View all Xerox M20I manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
Basic Network Installation Manually setting TCP/IP Addresses At the WorkCentre M20i, perform these steps: HINT: Xerox CentreWare Internet Services can also be used to configure the WorkCentre M20i, refer to the Internet Services chapter for instructions. When manually making the TCP/IP settings, you will need to know the following information: ¾ The IP address. ¾ The subnet mask, if required. ¾ The Gateway address, if required ¾ The primary and Secondary DNS address, if required. 1 ¾ Ensure that the Ethernet Port has been configured (see "Ethernet Port" on page 2-3). 2 ¾ Press the [Machine Status] button. 3 ¾ Press or until System Admin Tools is displayed and press [Enter]. ¾ If the System Admin Tools have been passcode protected, type in the password and press [Enter]. System Admin Tools [Passcode Protect] 4 ¾ Press or until Network Setup is displayed and press [Enter]. System Admin Tools [Network Setup] Page 2-10 Xerox WorkCentre M20i System Administration Guide