Xerox M20I System Administration Guide - Page 81
Enabling/Disabling LPR/LPD
UPC - 095205244205
View all Xerox M20I manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 81 highlights
Advanced TCP/IP Setup Enabling/Disabling LPR/LPD This procedure is used to enable or disable Line Printer Remote/Line Printer Daemon (LPR/ LPD) port on the WorkCentre M20i. Once the port is enabled, you can change the LPR port number. To enable the LPR/LPD port, at the WorkCentre M20i, perform these steps: 1 ¾ Ensure that the basic TCP/IP settings have been made (see "Basic TCP/IP Settings" on page 2-5). 2 ¾ Press the [Machine Status] button. 3 ¾ Press or until System Admin Tools is displayed and press [Enter]. ¾ If the System Admin Tools have been passcode protected, type in the password and press [Enter]. System Admin Tools [Passcode Protect] 4 ¾ Press or until Network Setup is displayed and press [Enter]. System Admin Tools [Network Setup] 5 ¾ Press or until Configure Network is displayed and press [Enter]. Network Setup [Config. Network] Xerox WorkCentre M20i System Administration Guide Page 6-3