Xerox M20I System Administration Guide - Page 48

NetWare Using NetWare Utilities Installation Procedure There are three stages required to install the WorkCentre M20i on a NetWare network using NetWare utilities: ¾ Network Communication Setup This procedure will enable the WorkCentre M20i to communicate on the NetWare network. ¾ NetWare Setup This procedure is used to setup the network using NetWare utilities, for example NWADMIN. ¾ Test Print A print job should be submitted to ensure the WorkCentre M20i has been installed and configured correctly. If running NLSP, ensure that RIP/SAP compatibility is configured on the same segment as the WorkCentre M20i. Network Communication Setup At the WorkCentre M20i, perform these steps: HINT: Xerox CentreWare Internet Services can also be used to configure the WorkCentre M20i, refer to the Internet Services chapter for instructions. 1 ¾ Ensure that the Basic TCP/IP settings have been configured (see "Network Communication Setup" on page 2-8). 2 ¾ Press the [Machine Status] button. 3¾ ¾ Press or until System Admin Tools is displayed and press [Enter]. ¾ If the System Admin Tools have been passcode protected, type in the password and press [Enter]. System Admin Tools [Passcode Protect] Page 3-8 Xerox WorkCentre M20i System Administration Guide